Parallel port: Difference between revisions
Jump to navigation
Jump to search
[unchecked revision] | [unchecked revision] |
Content added Content deleted
m (typofixing) |
(added category 'common devices') |
||
Line 13: | Line 13: | ||
==Control Register== |
==Control Register== |
||
Address = Base Address + 2 |
Address = Base Address + 2 |
||
[[Category:Common Devices]] |
Revision as of 03:18, 24 October 2007
The parallel port uses a sub-d 25 connector to provide a 8-bit data bus. It is commonly used by printers. There are 3 kinds of parallel ports: Standard Parallel Port (SPP), Enhanced Parallel Port (EPP) and Extended Capabilities Parallel Port (ECP). iirc they are all part of IEEE Standard 1284, or is it just the second two?
Registers & Common Address
Common base addresses are:
- LPT1: 0x3BC/0x378
- LPT2: 0x278
Data Register
Address = Base Address + 0
Any byte writen to this register is put on pins 2 through 9 of the port. Any read from this register reflects the state of the port.
Status Register
Address = Base Address + 1
Control Register
Address = Base Address + 2