Parallel port: Difference between revisions
Jump to navigation
Jump to search
[unchecked revision] | [unchecked revision] |
Content deleted Content added
added category 'common devices' |
mNo edit summary |
||
Line 1:
The parallel port uses a sub-d 25 connector to provide a 8-bit data bus. It is commonly used by printers. There are 3 kinds of parallel ports: Standard Parallel Port (SPP), Enhanced Parallel Port (EPP) and Extended Capabilities Parallel Port (ECP). iirc they are all part of IEEE Standard 1284, or is it just the second two?
==Pin types==
=Registers & Common Address=▼
Most parallel ports come in either 36, 25 or 9 pin varieties. 25 and 9 pins being the most common.
▲==Registers & Common Address==
Common base addresses are:
* LPT1:
* LPT2: 0x278 (IRQ 6)
* LPT3: 0x3BC (IRQ 5)
==Data Register==
Address = Base Address + 0
|
Revision as of 13:57, 23 March 2008
The parallel port uses a sub-d 25 connector to provide a 8-bit data bus. It is commonly used by printers. There are 3 kinds of parallel ports: Standard Parallel Port (SPP), Enhanced Parallel Port (EPP) and Extended Capabilities Parallel Port (ECP). iirc they are all part of IEEE Standard 1284, or is it just the second two?
Pin types
Most parallel ports come in either 36, 25 or 9 pin varieties. 25 and 9 pins being the most common.
Registers & Common Address
Common base addresses are:
- LPT1: 0x378 (or occasionally 0x3BC) (IRQ 7)
- LPT2: 0x278 (IRQ 6)
- LPT3: 0x3BC (IRQ 5)
Data Register
Address = Base Address + 0
Any byte writen to this register is put on pins 2 through 9 of the port. Any read from this register reflects the state of the port.
Status Register
Address = Base Address + 1
Control Register
Address = Base Address + 2